2-691-651-13(2)
SXRD Projection TV
GB
Operating Instructions
Before operating the TV, please read the “Safety
information” section of this manual.
Retain this manual for future reference.
KS-70R200A
KS-60R200A
KS-50R200A
© 2006 Sony Corporation
Table of Contents
Overview of the TV buttons and indicators........................................................................14
Picture menu...........................................................................................................................21
AV Setup menu.......................................................................................................................30
GB
Specifications..........................................................................................................................42
GB
3
Start-up Guide
Carrying your TV
KS-60R200A/50R200A
Carrying the TV requires at least two people.
When moving the TV, place one hand in the hole on
the lower portion of the TV while supporting the top
with the other hand, as shown in the illustration below.
1: Installing the TV
Recommended viewing area
Your viewing position may affect the picture quality.
For the best picture quality, install your TV within the
areas shown below.
\
Model
Viewing distance
KS-70R200A
min. 2.4 m
KS-60R200A
KS-50R200A
min. 2.2 m
min. 2.0 m
KS-70R200A
Horizontal Viewing Area
Carrying the TV requires at least three people. Do not
hold by the pedestal or the speakers of the TV. Doing
so may cause these parts to break off.
When moving the TV, one person should lift the back,
and the other two people should lift the front and
sides. Support the TV by placing your hands in the
holes on the lower part of the TV set, and then lift
carefully.
Vertical Viewing Area
Notes
•
Do not hold by the pedestal or the front panel of the TV.
Doing so may cause these parts to break off.
Do not grasp the
pedestal or the front
panel of the TV.
•
•
To ensure the safety of children and the TV, keep children
away from the TV during installation. Climbing on or pushing
the TV or its stand may cause it to fall and damage the TV.
When installing your TV against a wall, keep your TV at
least 10 cm away from the wall to provide proper
ventilation.
GB
4
Preventing the TV from toppling over
Installing the TV against a wall
Keep the TV at least 10 cm away from the wall to
provide proper ventilation.
KS-60R200A/50R200A
Blocking the ventilation opening of the cooling fan
may damage the TV.
Allow this much space
10 cm
SU-GW12
30 cm
10 cm
10 cm
KS-70R200A
Never install the TV as follows
Air circulation is
blocked.
Warm air is blown to
ventilation openings.
SU-RS51U
Note
Do not install the TV near any ventilation, as it may affect the
normal TV operating temperature.
Note
When using the SU-GW12 stand (for KS-60R200A/
50R200A, not supplied) or SU-RS51U stand (for KS-
70R200A, not supplied) for your TV, you must use the
support belt.
GB
5
2: Connecting an
3: Inserting batteries
antenna/VCR
into the remote
Push and slide to open.
Connecting an antenna only
Antenna cable (not supplied)
Notes
•
•
Observe the correct polarity when inserting batteries.
Do not use different types of batteries together or mix old
and new batteries.
•
Dispose of batteries in an environmentally friendly way.
Certain regions may regulate disposal of the battery.
Please consult your local authority.
AC power cord (supplied)
•
•
Handle the remote control with care. Do not drop or step
on it, or spill liquid of any kind onto it.
Do not place the remote control in a location near a heat
source, or in a place subject to direct sunlight, or in a damp
room.
Connecting an antenna and VCR
AC power
cord
(supplied)
Antenna cable
(not supplied)
A/V cable
(not supplied)
S video cable
(not supplied)
VCR
GB
6
3 Press F/f to select the language
displayed on the menu screens, then press
.
4: Selecting the
language
The message confirming the TV start auto-tuning
appears on the screen, then go to “5: Auto tuning
, 1
2
2
3
3
1 Connect the TV to your AC power outlet
(110-240 V AC, 50/60 Hz).
2 Press 1 on the TV (front).
When you switch on the TV for the first time, the
Language menu appears on the screen.
When the TV is in standby mode (the 1 (on/
standby) indicator on the TV (front) is red), press
TV "/1 on the remote to switch on the TV.
GB
7
5 Press MENU to exit.
The TV has now tuned in all the available channels.
5: Auto tuning the TV
The TV will search for and store all available TV
channels.
6 PressG/g to select the desired setting in
“Display this menu next time ?” dialog, then
press
to exit.
Tip
If “Yes” is selected and the TV is switched off by pressing 1
on the TV, or is disconnected from the AC power outlet, the
auto startup procedure restarts the next time the TV is
switched on.
1,4,6
1,4,6
3,5
1 Press G/g to select “OK”, then press
.
The TV starts searching for all available channels.
This may take some time, please be patient and do
not press any buttons on the TV or remote.
If a message appears for you to confirm the
antenna connection
No channels were found. Check the antenna
connection and press G/g to select “Yes”, then
press
to start auto-tuning again.
2 When the Program Sorting menu appears
on the screen, follow the steps of “Program
If you do not change the order in which the channels
are stored on the TV, go to step 3.
3 Press MENU to display the Clock Set
menu.
4 Press F/f/G/g to set the day and time
(hour and minute), then press
.
GB
8
|