8904A-04
S E R V I C E
N O T E
SUPERSEDES: None
8904A Multifunction Synthesizer (Option 006/H16)
Serial Numbers: 2948A04593 / 2948A04693
Replacement of Audio Transformer to Correct Inverted Waveform
Parts Required:
9100-4833, Audio Transformer
Situation:
Some 8904A Multifunction Synthesizer (Option 006/H16) with serial numbers listed
above may have inverted OUTPUT 1 waveforms. This is because the primary of Audio
Transformer T1 was wound backwards, resulting in a 180 degree phase shift from the pri-
mary to the secondary. OUTPUT 2 waveforms are not affected.
The most noticeable waveform is the ramp because it is asymmetrical. Sinewave, square
and triangle waveforms are inverted but are less noticeable because they are symmetrical.
Normally the ramp waveform starts at the negative peak and ramps up to the positive
peak. Suspect units will exhibit an inverted ramp waveform, i.e., the ramp starts at posi-
tive peak and ramps down to the negative peak.
NOTE: Option 006/H16 is not indicated on the front panel LCD display when ann instru-
ment preset is performed. Verify if Option 006/H16 is installed by inspecting the option
labelon the rear panel of the unit.
Continued
DATE: 01 January 1992
ADMINISTRATIVE INFORMATION
SERVICE NOTE CLASSIFICATION:
MODIFICATION RECOMMENDED
IMMEDIATELY
ACTION
CATEGORY:
STANDARDS:
ON SPECIFIED FAILURE
AGREEABLE TIME
LABOR: 1.0 Hours
SERVICE
INVENTORY:
USED
PARTS:
LOCATION
CATEGORY:
RETURN
SCRAP
RETURN
SCRAP
CUSTOMER INSTALLABLE
ON-SITE
SEE TEXT
SEE TEXT
SERVICE CENTER
RESPONSIBLE UNTIL: 1000
UNTIL: 01 January 1997
PRODUCT’S SUPPORT LIFE
AVAILABILITY:
AUTHOR: LHL
ADDITIONAL INFORMATION:
ENTITY: 1000
© 1991 AGILENT TECHNOLOGIES
PRINTED IN U.S.A.
1 of 2
|