Active Holder
for Fixed Installation
With Molex adapter system
New improved charger
An active holder with a straight cable with
open end for fixed installation and a cable with
Molex adapter system. The cables are to be
connected inside the dashboard, this gives a
discreet, neat installation without cables
hanging over the interior.
The 2nd Generation Molex active holder has
now been released. The charger has many
improved features, such as
- New overmoulded connector
- Improved protection against peaks
- Built-in resettable fuse in the box (2 A)
- Improved overload protection
You can choose to use the holder as an active
holder only for charging, or to connect an
adapter to the Molex connector for additional
features. Then you can use the holder also for
power supply of a GPS receiver or other own
solutions. Can not be used for data comm-
unication
- New box design, with ventilation holes
- More efficient charging, generates less heat
The product is CE and E approved.
Connect the power cable with a 2 A fuse.
5 Volt out.
2 A charger.
12/24 Volt.
Professional installation recommended.
The holder is attached onto a tilt swivel so it
can be adjusted in order to avoid light
reflection. Attach onto the ProClip Mounting
Platform.
|
Belkin Film Camera F1D084vea2 User Manual
Binatone Microphone 3401 User Manual
Black Decker Trimmer GH600 User Manual
Bosch Appliances Boiler 28CDI User Manual
Bosch Appliances TV Mount LTC 9349MK User Manual
Butler Coffeemaker 645 260 User Manual
Can Am Automobile DS 70 User Manual
Carson Automobile Alarm SC 1000 User Manual
Castelle Modem 10031161 User Manual
Cisco Systems Network Card 100 200 300 400 User Manual