Pack-Away® Table Set for 2 #2794-490
Plastic Snaps
Chair
Leg Cross Bar
Auto Lock
Leg Extenders
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Open table top case until case lays flat. Table
top will automatically lock open.(see Illus. 1)
Remove chairs from their snapped in position
in the table top case.
Grab the leg cross bar near the center of the
open case and lift until you lock the leg
assembly into place. Repeat for second leg.
At this point you may use as a coffee style
table. Simply flip table over for use.
For traditional table height remove the leg
extenders from the case and insert into the
open end of the leg assembly. Repeat for
second leg extension.
To Pack-Away:
W A R N IN G
Read instructions and warnings before set up and use.
1. Check to ensure product is not damaged,prior to use.
If product is damaged, do not use.
2. Use care when setting up and taking product
– avoid pinch points.
• Turn table top over onto top.
• Remove leg extensions and snap into place along each side
and in the middle with the cross bar towards the center of the table.
• Unlock leg assemblies and fold down into snapped stored position.
3. Not for use by unsupervised children.
4.Never use on uneven or soft surface.
5. When sitting, do not lean back on only two legs.
• Collapse chairs by lifting the seat sections upward and pull away from each other
until the legs collapse together and the then fold the seat sections down.
• Snap chairs into place. The wide seat portion fits into the center section
with the logo facing the side with the table top lock. (See Fig. 1)
Fig. 5
• Unlock table top on the front side of the
table and fold close. (See Illus. 1)
Chair Assembly
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
Lock case closed and you are ready to store.
Grab each side of the widest part of the seat
and lift to form a “T”. Then push together
forming the chair. Repeat for second chair.
Illus. 1
MADE IN CHINA
When closing table, be sure to unlock lever.
PRINTED IN CHINA Rev. 4/04
|